Page 1 sur 1

height/width ratio

Publié : 15 août 2008 0:11
par jimclatfelter
Is there a way to enter a height/width ratio for a retangular selection. I like that I can click on = (square), 4:3, and 3:2, but those don't cover the range of ratios that I need for various print sizes. Right now I switch to Image Analyzer to make my crop if I need a ratio other than 1:1, 4:2, or 3:2. Is there presently a way do get other ratios. If there isn't, I suggest it for a new feature.

Thanks,
Jim

Re: height/width ratio

Publié : 24 août 2008 10:55
par Antonio
Not for the moment :cry:

You can use the manual settings to enter the size with correct ratio and after use the shift key to keep the ratio

Re: height/width ratio

Publié : 29 août 2008 0:40
par jimclatfelter
Hello Antonio,

That's what I was looking for. I didn't know about Manual Settings (Ctrl-G). Now I can do just what I need.

Thanks,
Jim